Night Vision System Camera -R212-, REMOVING AND INSTALLING: Notes

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

The Night Vision System Camera -R212- is located in the radiator grille.

Removing

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

Vehicles without radiator shutter:

-- Remove the lock carrier cover. Refer to OVERVIEW - BUMPER COVER .

-- Remove the upper air guide. Refer to OVERVIEW - RADIATOR/RADIATOR FAN (2.0L) / OVERVIEW - RADIATOR/RADIATOR FAN (3.0L) .

Vehicles with radiator shutter:

-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

Continuation for All Vehicles:

Fig 1: Removing Washer Fluid Hose

Courtesy of AUDI OF AMERICA, LLC

-- Release the clamp -arrow- and remove the washer fluid hose -1-.

-- If necessary seal the washer fluid hose.

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Night Vision System Camera -R212- with the retaining plate -1- from the radiator grille and guide it out upward. Pay attention that the spray nozzle is not damaged.

-- Release and disconnect the connector -2- from the Night Vision System Camera -R212-.

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Night Vision System Camera -R212- -1- from the retaining plate -2-.