Windshield Projection Head Up Display Control Module, Removing And Installing, From Product Improvement: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Press out the cover -2- from the instrument panel -1- using the Wedge Set: T10383 .

-- Cover the control module -2- with a soft towel.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .

CAUTION:

There is a risk of destroying the windshield projection head up display control module.

- Only remove the designated bolts from the control module.

- Never remove the bolts for the housing upper section.

-- Remove the bolts -1, 3 and 4-.

-- Lift the control module -2- out slightly and disconnect the connectors -3 and 4-.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wiring harness -1- -arrow-.

-- Remove the control module.

Removing the Exterior Bracket:

Courtesy of AUDI OF AMERICA, LLC

-- Mark the installation position of the bracket -1- on the instrument panel crossmember.

-- Remove the instrument panel. Refer to INSTRUMENT PANEL, REMOVING AND INSTALLING .

-- Remove the nuts -arrows-.

-- Remove the bracket -1-.

Removing the Inner Bracket:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the instrument panel. Refer to INSTRUMENT PANEL, REMOVING AND INSTALLING .

-- Mark the installation position of the bracket -1- on the instrument panel crossmember.

-- Remove the nuts -arrows-.

-- Remove the bracket -1-.