Driver Assistance Systems Control Module -J1121-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Lay the carpet at the left front of the center console. Refer to CARPET, REMOVING AND INSTALLING .

-- Unclip the front seat mount from the vehicle floor. Refer to OVERVIEW - FRONT SEAT .

-- Remove the nuts -arrows-.

Courtesy of AUDI

-- Remove the rear emergency release cable -1- from the Driver Assistance Systems Control Module -J1121- bracket and place it aside.

-- Unclip the wiring harness from the impact guard -1- -arrow-.

Courtesy of AUDI

-- Remove the bolts -2 and 4-.

-- Lift the Driver Assistance Systems Control Module -J1121- with the bracket -3- and impact guard -1- just until the connectors are accessible.

Vehicles with Driver Assistance Systems Control Module -J1121- "Low"

Courtesy of AUDI

-- Remove the bolts -arrows-.

-- Loosen the clip -3- and remove the impact guard -4-.

-- Release and disconnect the connectors -2-.

-- Remove the Driver Assistance Systems Control Module -J1121- -1-.

Vehicles with Driver Assistance Systems Control Module -J1121- "High"

Courtesy of AUDI

-- Remove the bolts -arrows-.

-- Loosen the clip -3- and remove the impact guard -4-.

-- Release and disconnect the connectors -2-.

-- Remove the Driver Assistance Systems Control Module -J1121- -1-.