Overview - Laser Distance Regulation Control Module
WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Cover
- For the washer nozzle
- Laser Distance Regulation Control Module -J1122-
- Removing and Installing. Refer to Laser Distance Regulation Control Module -J1122-, REMOVING AND INSTALLING .
- Adjusting. Refer to LASER SENSOR (Laser Distance Regulation Control Module -J1122-), ADJUSTING, FROM PRODUCT IMPROVEMENT .
- Mount
- For Laser Distance Regulation Control Module -J1122-
- Removing and Installing. Refer to ADJUSTER FOR Laser Distance Regulation Control Module -J1122-, REMOVING AND INSTALLING .
- Bolt
- 6 Nm
- Adjuster
- Removing and Installing. Refer to ADJUSTER FOR Laser Distance Regulation Control Module -J1122-, REMOVING AND INSTALLING .
- Note the adjustment dimension. Refer to Installing - Measure the dimension -a- at the adjuster using the Digital Caliper:VAS6335 and correct if necessary. .
- Spring
- Washer Fluid Hose
- Spray Nozzles
- For Laser Distance Regulation Control Module -J1122-
- Overview. Refer to OVERVIEW - HEADLAMP WASHER SYSTEM
- Bolt
- Tightening specification. Refer to OVERVIEW - HEADLAMP WASHER SYSTEM
- Quantity: 2
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Quantity: 4
- Bolt
- 6 Nm
- Quantity: 2
Tightening Specifications and Sequence Laser Distance Regulation Control ModuleJ1122 with bracket 5
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 to 4- | Install all the way by hand |
| 2. | -1 to 4- | 4 Nm |