Automatic Belt Retractor (Locking Function), Checking

The automatic belt retractor has two locking functions.

• The first locking function is initiated by the belt being jerked out of the automatic belt retractor (belt extraction acceleration).

Test 1 

-- Pull the seat belt webbing out of the automatic belt retractor quickly and firmly.

• No locking effect - replace the entire seat belt with seat belt latch.
• If there is difficulty extending or retracting the belt, first check if the position of the belt retractor has been changed.
• The second locking function is initiated by change in vehicle velocity (vehicle-dependent locking function).

Test 2 

• For safety reasons, the road test should be carried out on roads without traffic so that other motorists/pedestrians, etc. are not endangered.

-- Fasten the seat belt.

-- Accelerate the vehicle to 20 km/h (12.4 mph) (12.4 mph) (12.4 mph) and then perform a hard braking maneuver using the foot brake.

• Replace the entire seat belt with the seat belt latch if the seat belt is not locked by locking mechanism during the braking procedure.