Driver Assistance Systems Front Camera, Calibrating, Dynamic Calibration (Calibration Drive)

WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Calibrating the front camera is necessary:

The installation position of the Driver Assistance Systems Front Camera -R242- in the vehicle has changed.
Rear axle toe/chamber was adjusted.

Special tools and workshop equipment required

Vehicle Diagnostic Tester

Calibration Conditions

DTC memory is without relevant entry.

Procedure

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic operating mode.

-- Select the Test plan tab.

-- Select the Select individual test button and select the following tree structure consecutively:

Diagnostic-capable systems
00A5 - Driver Assistance Systems Control Module, MFK3
00A5 - Functions
00A5 - Calibration

-- Start the selected program and based on the calibration from a short drive, follow the instructions on the Vehicle Diagnostic Tester display.

Dynamic Calibration of Several Driver Assistance Systems

The front camera and the other driver assistance systems can alternatively be calibrated together during the calibration run, to do so, select the following tree structure:

Diagnostic-capable systems
00A5 - Driver Assistance Systems Control Module, MFK3
00A5 - Functions
00A5 - Dynamic Calibration of several Driver Assistance Systems

-- Start the selected program and based on the calibration from a short drive, follow the instructions on the Vehicle Diagnostic Tester display.