Driver Assistance Systems Control Module -J1121-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S6, 2022 Audi A6 Quattro, 2021 Audi S6, 2021 Audi A6 Quattro, and 2020 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
-- Lay the carpet at the left front of the center console. Refer to CARPET, REMOVING AND INSTALLING .
-- Remove the vehicle interior footwell vent. Refer to OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN VEHICLE INTERIOR .
-- Loosen the air duct to the footwell vent and lift it upward as much as possible.
-- Remove the screws -arrows-.
-- Free up the wires -1, 2, and 4-.
-- Guide out the mount -3- with the driver assistance systems control module and lay it aside.
-- Disconnect the connectors -2 through 5-.
-- Remove the screws -arrows-.
-- Remove the mount -6- from the driver assistance systems control module -1-.