Windshield Projection Head Up Display Control Module, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi A6 allroad. However, it is still accessible from the selected car via links, so may be relevant.

If the Windshield Projection Head Up Display Control Module -J898- is being replaced, then perform the test plan for replacing the control module.

-- Perform the "control module, replacing" function using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .

Continuation

-- Press out the cover -2- from the instrument panel -1- using the Wedge Set:T10383 .

Courtesy of AUDI OF AMERICA, LLC

-- Cover the Windshield Projection Head Up Display Control Module -J898- -2- with a soft towel.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .

CAUTION:

There is a risk of destroying the windshield projection head up display control module.

- Only remove the designated bolts from the control module.

- Never remove the bolts for the housing upper section.

-- Remove the bolts -1-, -3- and -4-.

-- Slightly pry out the control module -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -3- and -4-.

-- Free up the wiring harness -1- -arrow-.

-- Remove the control module.