Night Vision System Camera -R212-, REMOVING AND INSTALLING: Notes

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The Night Vision System Camera -R212- is located in the radiator grille.

Removing

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Remove the lock carrier cover. Refer to Front Bumper .

-- Remove the upper air guide. Refer to OVERVIEW - RADIATOR/RADIATOR FAN (EA 888EVO4) , or OVERVIEW - RADIATOR/RADIATOR FAN (EA 839) .

-- Release the clamp -arrow- and remove the washer fluid hose -1-.

Fig 1: Removing Washer Fluid Hose

Courtesy of AUDI OF AMERICA, LLC

-- If necessary seal the washer fluid hose.

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Night Vision System Camera -R212- with the retaining plate -1- from the radiator grille and guide it out upward. Pay attention that the spray nozzle is not damaged.

-- Release and disconnect the connector -2- from the Night Vision System Camera -R212-.

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Night Vision System Camera -R212- -1- from the retaining plate -2-.