Windshield Projection Head Up Display Control Module, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

There is a risk of destroying the windshield projection head up display control module.

- A control module that has fallen down cannot be used again.

- When inserting the control module, never apply pressure on the housing upper section.

-- Check the control module function.

Conditions

A number must be visible on the windshield.

If the Windshield Projection Head Up Display Control Module -J898- was replaced, then complete the test plan for replacing the control module.

-- Complete the "control module, replacing" function using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .

Continuation