Multifunction Transmission Range Switch, Removing And Installing: Installing

Fig 1: Identifying Selector Shaft Components

Courtesy of AUDI OF AMERICA, LLC

Install In The Reverse Order Of Removal While Noting The Following:

-- Attach The Multifunction Transmission Range Switch -4- To The Selector Shaft -6-.

-- Screw In The Bolts -5- Hand-Tight.

-- Bend Back The Hooks On The Lock Washer -2-.

-- Mount The Washer -3- On The Selector Shaft -6-.

-- Install The Washer -2- With The Hooks Facing Upward.

-- Install The Washer -2- With The Long Narrow Guides Into The Long Narrow Recesses In The Selector Shaft -6-.

-- Tighten The Nut -1- And Secure It By Bending The Hook On The Lock Washer -2- Upward.

Tip:

Replace The Lock Washer If One Or Several Of The Hooks Break Off When Bent.

-- Before Installing The Selector Lever On The Selector Shaft, Adjust The Multifunction Transmission Range Switch -F125-. Refer To MULTIFUNCTION TRANSMISSION RANGE SWITCH, ADJUSTING .

Attach The Selector Lever -3- To The Selector Shaft -4-.

-- Shift The Transmission Into "P" With The Selector Lever -3-. This Means Pushing The Selector Lever -3- In The Opposite Direction Of Travel All The Way Toward The Rear.

-- Then Use The Selector Lever -3- To Move The Transmission Into The "N" Position. Push The Gearshift Lever -3- Two Positions Forward In The Direction Of Travel.

-- Mount The Spring Washer -2- And The Nut -1- On The Selector Shaft -4-.

-- Tighten The Nut -1- To The Tightening Specification.

-- Adjust The Selector Lever Cable. Refer To SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Check The Selector Mechanism. Refer To SHIFT MECHANISM, CHECKING .

-- Install The Air Filter Housing. Refer To AIR FILTER HOUSING, REMOVING AND INSTALLING (DSNA) , or AIR FILTER HOUSING, REMOVING AND INSTALLING (DSPA) .