Bevel Box, Installing: Installing

Install in the reverse order of removal while noting the following:

• Tightening specifications. Refer to BEVEL BOX, TIGHTENING SPECIFICATION .

-- Grease the splines on the bevel box.

Courtesy of AUDI OF AMERICA, LLC

-- Insert the bevel box and press it all the way on the transmission.

Tip

• If the tooth position is incorrect the bevel box cannot be pressed against the transmission. To do so turn the flange shaft.
• If the tooth position is correct and it is guided centered, the bevel box slides against the transmission all the way.

-- Tighten the bevel box. Refer to Figure.

-- Install the driveshaft. Refer to the appropriate service information .

-- Install the subframe with the steering gear. Refer to SUBFRAME WITH STEERING GEAR, REMOVING AND INSTALLING .

-- Check the gear oil level in bevel box. Refer to GEAR OIL, CHECKING LEVEL .