Electronic Damping Basic Setting: Notes

Adapting the height sensor end stops

Select this basic setting for the following operations:

• The threaded connection for a level control system sensor was loosened.
• A level control system sensor was removed and installed.
• A front or rear shock absorber was replaced.

Requirement:

• The vehicle must be raised on the hoist and the wheels are hanging freely, whereby the shock absorbers move into the end stops.

Adapting the height sensor zero position

Select this basic setting for the following operations:

• The threaded connection for a level control system sensor was loosened.
• A level control system sensor was removed and installed.
• The Drivetrain Control Module -J775- was removed and installed.

Requirements:

• The vehicle must be standing on a level surface.
• The vehicle may not be loaded.

Calibration of inertial sensors (sensors in control module)

Select this basic setting for the following operation:

• The Drivetrain Control Module -J775- was replaced

Requirements:

• The vehicle must be standing on a level surface.
• The vehicle may not be loaded.