Functions Changed After Vehicle Programming E60, E61, E63, E64: Notes
After a vehicle has been programmed, the customer may notice changes in certain functions. Changes in function depend on the current vehicle data status and the new data status.
Procedure:
- Connect the vehicle to the BMW diagnosis system
- Read off the present vehicle data status as follows:
- Call up the program "CIP".
- Select "Vehicle order" and confirm.
The current vehicle data status is displayed.
- Make a note of this data status.
- Locate the vehicle data status in the left-hand column of the table.
- Click on the hotspot on this line in the right-hand column.
- Print off the enclosure and attach to the job order.
If the target data status in the table does not correspond to the current CIP version in the workshop, you should still proceed as described above.
VEHICLE DATA STATUS E60, E61, E63, E64
| Vehicle data status | Target data status / CIP version |
|---|---|
| E060-05-06-500 CIP V 17.1 |
|
| E060-05-06-500 | No change |
| E060-05-03-520 | No change |
| E060-05-03-510 | No change |
| E060-04-09-555 | Enclosure F05 |
| E060-04-09-504 | Enclosure F05 |
| E060-04-09-503 | Enclosure F05 |
| E060-04-06-500 | Enclosure F04 |
| E060-04-03-506 | Enclosure F03 |
| E060-04-03-505 | Enclosure F03 |
| E060-03-12-528 | Enclosure F02 |
| E060-03-12-527 | Enclosure F02 |
| E060-03-12-525 | Enclosure F02 |
| 5.35 | Enclosure F02 |
| 5.33 | Enclosure F02 |
| 5.31 | Enclosure F02 |
| 5.22 | Enclosure F02 |
| 5.21 | Enclosure F02 |
| 5.13 | Enclosure F02 |
| 4.64 | Enclosure F02 |
| 4.61 | Enclosure F02 |
| 4.60 | Enclosure F02 |
| 4.54 | Enclosure F01 |
Customers should be informed of any changes in function. Let them keep the printout as an enclosure to the Owner's Handbook.