E65/E66 CIP Programming Setup

Attach the OPPS and GT1 in accordance to Cabling setup 1 or 2.

• Attach the MOST bus programming cable (663 121) to the OPPS MOST connection (1).
  Fig 1: Identifying OPPS Cable

  Courtesy of BMW OF NORTH AMERICA, INC.
  Fig 2: Identifying MOST Connection

  Courtesy of BMW OF NORTH AMERICA, INC.
• Run the MOST bus cable to the glove compartment (4).
  Fig 3: Running Most Bus Cable To Glove Compartment

  Courtesy of BMW OF NORTH AMERICA, INC.
• Pull down the trap door inside the glove compartment
• Disconnect the MOST bus interface (1)
• Plug the MOST bus harness (2) into the MOST programming cable (3).
  Fig 4: View Of GT1 Wired To Opps (Setup #1)

  Courtesy of BMW OF NORTH AMERICA, INC.