61 00 ... Notes On Handling Optical Fibers
CAUTION:
To avoid damage when handling optical fibers, comply with the following points:
- The minimum permitted bending radius is 25 mm
- Do not subject optical fibers to compressive and tensile load
- Protect optical fibers against the effects of heat =85°C (e.g. during welding work, drying work with infrared heater or hot air blower)
- Optical fibers are permitted to show only one junction point (bridge), replace optical fibers if necessary
NOTE:
The optical fibers are colored differently as follows:
- Green=MOST (M edia O riented S ystems T ransport) optical fibers
- Yellow=ISIS (I ntelligent S afety and I ntegration S ystem) optical fibers
- Orange=repair optical fibers
Follow instructions for PROCESSING CABLES AND OPTICAL FIBERS .