32 00... Chassis/wheel alignment check procedure
CHASSIS/WHEEL ALIGNMENT PROCEDURE CHART
| Check adherence to 32 00... Test conditions for chassis/wheel alignment check | ||||||
| I V |
||||||
| Position vehicle on measuring stand | ||||||
| I V |
||||||
| Measure vehicle ride height | OK -> | Carry out chassis/wheel alignment check with ride-height measurement without load, see 32 00 155 KDS chassis/wheel alignment check with ride-height measurement without load . | ||||
| Read off setpoint value in KDS Tolerance-20 / +40 mm per wheel permissible Difference between left / right max. 10 mm permissible |
||||||
| Not OK / no data I V |
||||||
| Move vehicle into normal position, see 32 00... Moving vehicle into normal position . | ||||||
| Introduce load and measure ride heights | ||||||
| Read off setpoint value in KDS Tolerance ± 10 mm per wheel permissible Difference between left / right max. 10 mm permissible |
Not OK -> | |||||
| OK I V |
Check suspension for damage, repair if necessary | |||||
| Move vehicle into design position, see 32 00... Moving vehicle into design position . | <- Not OK | |||||
| Add/distribute weights and measure ride heights | ||||||
| Read off setpoint value in KDS Tolerance ± 2 mm per wheel permissible Difference between left / right max. 2 mm permissible |
||||||
| I V |
||||||
| Carry out chassis/wheel alignment check with load up to design position, see 32 00 155 KDS chassis/wheel alignment check with ride-height measurement without load . | ||||||