12 90 ... Removing And Installing/Replacing Electronics Box
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
NOTE:
Follow instructions for removing and installing electronic control units. See INSTRUCTIONS FOR REMOVING AND INSTALLING ELECTRONIC CONTROL UNITS .
Necessary preliminary tasks:
- Read fault memory.
- Disconnect negative battery cable
- Remove ELECTRONICS BOX FAN
- Remove DISTRIBUTION BOX (PASSENGER COMPARTMENT)
- Release control unit holder; if necessary, release CD changer
Release screws (arrows) behind sound insulation.
Disconnect wiring harness on engine compartment side on right.
Remove electronics box.
Installation:
Make sure gasket (1) is correctly seated on electronics box.
Read fault memory.