Top Rear Side View Camera Control Module Fails Programming And Calibration (66 01 11)

Publication date: 2011-05-26
Reference number: 66 01 11

TOP REAR SIDE VIEW CAMERA CONTROL MODULE FAILS PROGRAMMING AND CALIBRATION

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI B66 01 11, Date of Issue: May 2011

BMW:	F01, F02 (7 Series); F04 (ActiveHybrid 7); F07 (5 Series); Vehicles produced to 2/28/10 or with an integration level prior to F001-10-03-501
GROUP:	Distance Systems, Cruise Control, Remote Control

Superceded Bulletin(s): SI B66 01 11, Date of Issue: May 2011

NOTE: This Service Information bulletin supersedes SI B66 01 11 dated May 2011.

SUBJECT

Top Rear Side View Camera Control Module Fails Programming and Calibration

SITUATION

The TRSVC (Top Rear Side View Camera) control module may fail programming using ISTA/P (Integrated Service Technical Application/Programming) 2.41.0, 2.41.1 or 2.41.2.

The affected vehicles are equipped with at least one of the following options:

508 - Park Distance Control (PDC)
3AH - Reversing Camera
5DK - Side View Camera

CAUSE

Software error in the TRSVC control module

PROCEDURE

To avoid having the TRSVC (Top Rear Side View Camera) control module fail during a vehicle software update procedure, only program these vehicles with ISTA/P 2.41.3 or higher.

If you had one of these vehicles where the TRSVC (Top Rear Side View Camera) control module failed during a vehicle software update procedure, reprogram the vehicle with ISTA/P 2.41.3 or higher. Submit the repair as outlined below.

Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.

For information on programming and coding with ISTA/P, refer to CenterNet / Aftersales / Aftersales Business Development & Marketing Portal / Service Operations / Workshop Technology / Vehicle Programming.

WARRANTY INFORMATION

Covered under the terms of the BMW New Vehicle/SAV Limited Warranty as applicable.

Defect Code: 66 53 04 02 00

WARRANTY INFORMATION

Labor Operation:	Labor Allowance:	Description:
61 00 730	Refer to KSD2	Programming/encoding control unit(s)
Refer to KSD2	Refer to KSD2	Concluding work (initializations) as described in the ISTA/P final report

If other control module fails to program correctly, or initialization is required, work through the Measures Plan and/or Final Report. Claim this additional work under the defect code listed in this bulletin, referring to the KSD2 for the labor operation code and labor allowance.

Only one main labor operation can be claimed per repair visit. All other labor operations on the same line or other lines must be claimed using plus code labor operations.

Please refer to the Warranty Policy and Procedures Manual regarding proper support, documentation and archiving required for claims, as applicable.