32 00... Additional Work For Camber Correction
IMPORTANT:
Changes in axle geometry caused by accidents must under no circumstances be rectified by camber adjustment!
NOTE:
The upper control arm may only be replaced if the camber is outside the specified tolerance after toe adjustment.
Adjust toe-in. See 32 00 601 ADJUSTING TOE-IN ON FRONT AXLE .
Check camber values; if necessary, replace upper control arm with over-or under dimension variant. See 31 12 002 REMOVING AND INSTALLING/REPLACING TOP LEFT CONTROL ARM or 31 12 003 REMOVING AND INSTALLING/REPLACING TOP RIGHT CONTROL ARM .
NOTE:
Control arms with + or - marking (see Fig 1) are camber correction arms:
- Under dimension variant
+ Over dimension variant
- Under dimension variant
+ Over dimension variant
These camber correction arms are used to correct the camber values by 30 minutes. To be used only if the tolerance values are exceeded or undershot!
An unmarked control arm is a standard part.
After installation:
- Check directional stability of car; if necessary, repeat toe-in adjustment.