Service Action 730 - Program Control Units (SCR) (16 02 15)

SERVICE ACTION 730 - PROGRAM CONTROL UNITS (SCR)

SERVICE CAMPAIGN BULLETIN

SUBJECT

Service Action: Program Control Units (SCR) 

SITUATION

An error in the calculation of the DEF line pressure by the SCR module software could occur at temperatures below 32°F/0°C.

This could cause the Service Engine Soon light (MIL) to come on with a pressure plausibility fault stored in the SCR module.

AFFECTED VEHICLES

This Service Action involves certain BMW vehicles with the N47T and N57T diesel engines produced from 7/1/2013 to 12/8/2014.

First check if a Service Action label with a code number 730  is already attached to the B-pillar.

If a code number 730  has been punched out, the Campaign has already been performed and no further action is necessary.

Vehicles which require this Service Action to be completed will show it as "Open" when checked either in the "Service Menu" of DCSnet (Dealer Communication System) or with the Key Reader.

PROCEDURE

Program the vehicle using the latest version of ISTA/P.

F02	Target integration level: F001-14-11-505  or higher
F10	Target integration level: F010-14-11-505  or higher
F30, F31	Target integration level: F020-14-11-505  or higher
F15, F25, F26	Target integration level: F025-14-11-505  or higher

Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.

Always connect a BMW approved battery charger/power supply  (SI B 04 23 10  ).

For information on programming and coding with ISTA/P, refer to Centernet/Aftersales Portal/Service/Workshop Technology/Vehicle Programming.

LABEL INSTRUCTIONS

This Service Action has been assigned code number 730  . After the vehicle has been checked and/or corrected, obtain a label (SD 92-464) and:

1. Emboss your BMW center warranty number in the middle of the label (1);
2. Punch out code number 730  (2), printed on the label; and
3. Affix the label to the B-pillar as shown.

If the vehicle already has a label from a previous Service Action/Recall Campaign, affix the new label next to the old one. Do not affix one label on top of another one, because a number from an underlying label could appear in the punched-out hole of the new label.

WARRANTY INFORMATION

Reimbursement for this Service Action/Recall Campaign will be via normal claim entry utilizing the following information:

Defect Code:

00 16 92 01 00

Labor Operation:	Labor Allowance:	Description:
00 62 878	1 FRU	Programming and coding in conjunction with another campaign or repair (vehicle is already at the specified "Target" integration level or higher, no repair is necessary)
Or:
00 62 879	8 FRU	Program and encode control units (includes connecting an approved battery charger/power supply and performing a vehicle test)