Active Sound Design ASD Inoperative After Programming (65 17 15)
Publication date: 2015-10-01Reference number: 65 17 15
ACTIVE SOUND DESIGN ASD INOPERATIVE AFTER PROGRAMMING
TECHNICAL SERVICE BULLETIN
| BMW: | F30 (3 Series Sedan) |
| GROUP: | Audio, Navigation, Monitors, Alarms, SRS |
SUBJECT
Active Sound Design ASD inoperative after programming
SITUATION
After programming with ISTA/P V3.56.1
- Active Sound Design (ASD) no longer provides simulated engine sounds
- A fault is stored in the ASD module. Fault Code 8053A5 "ASD; invalid coding data for equalizing"
CAUSE
Invalid ASD coding data
CORRECTION
Program the vehicle using ISTA/P V3.57.1 (I-Level F020-15-07-502) or higher.
PROCEDURE
- Perform a vehicle test with ISTA.
- Follow test plan for fault code 8053A5
- Program vehicle with ISTA/P V3.57.1 (I-Level F020-15-07-502) or higher. Perform a complete vehicle encoding.
Always connect a BMW approved battery charger / power supply (SI B 04 23 10 ).
WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle Limited Warranty for Passenger Cars and Light Trucks or the BMW Certified Pre-Owned Program.
| Defect Code | 65 12 57 15 00 |
| Labor Operation: | Labor Allowance: | Description: |
|---|---|---|
| 00 00 006 | Refer to KSD2 | Performing "vehicle test" (with vehicle diagnosis system - checking faults) |
| And: | ||
| 61 21 528 | Refer to KSD2 | Connect an approved battery charger/power supply (indicated in KSD2 as "Charging battery") |
| And: | ||
| 61 00 730 | Refer to KSD2 | Programming / encoding control unit(s) |
If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead.
Refer to KSD2 for the corresponding flat rate unit (FRU) allowances.
Vehicle Programming and Encoding
If a control module was working properly and it fails to program correctly or requires initialization, please claim this additional work with the applicable KSD2 labor operations under the defect code listed above.
The diagnosis and repair of vehicles "arriving" with failed control modules or stored faults which will cause them to fail during programming cannot be claimed under the defect code listed in this bulletin.
Other Repairs
If other eligible and covered work is performed "prior" to programming and coding the vehicle, claim this work with the applicable defect code and labor operations listed in KSD2.