Service Action 695 - Program Control Units (OBD) (12 12 14)

SERVICE ACTION 695 - PROGRAM CONTROL UNITS (OBD)

TECHNICAL SERVICE BULLETIN

PERFORM THE PROCEDURE OUTLINED IN THIS SERVICE INFORMATION ON ALL AFFECTED VEHICLES BEFORE CUSTOMER DELIVERY OR THE NEXT TIME THEY ARE IN THE SHOP FOR MAINTENANCE OR REPAIRS. 

SUBJECT

Service Action: Program Control Units (OBD) 

SITUATION

Due to a DME software error, the required On Board Diagnosis data (OBD) monitoring of vehicle wheel speed does not function.

AFFECTED VEHICLES

This Service Action involves certain M3 and M4 vehicles with the S55 engine produced to 7/1/2014.

First check if a Service Action label with a code number 695  is already attached to the B-pillar.

If a code number 695  has been punched out, the Campaign has already been performed and no further action is necessary.

Vehicles which require this Service Action to be completed will show it as "Open" when checked either in the "Service Menu" of DCSnet (Dealer Communication System) or with the Key Reader.

PROCEDURE

Program the vehicle using ISTA/P 2.53.0 or a more recent version.

Target integration level: F020-14-07-501 or higher.

Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.

Always connect a BMW approved battery charger/power supply  (SI B04 23 10 ).

For information on programming and coding with ISTA/P, refer to Centernet/Aftersales Portal/Service/Workshop Technology/Vehicle Programming.

LABEL INSTRUCTIONS

This Service Action has been assigned code number 695  . After the vehicle has been checked and/or corrected, obtain a label (SD 92-439) and:

1. Emboss your BMW center warranty number in the middle of the label (1);
2. Punch out code number 695  (2), printed on the label; and
3. Affix the label to the B-pillar as shown.

If the vehicle already has a label from a previous Service Action/Recall Campaign, affix the new label next to the old one. Do not affix one label on top of another one because a number from an underlying label could appear in the punched-out hole of the new label.

WARRANTY INFORMATION

Reimbursement for this Service Action will be via normal claim entry utilizing the following information.

Defect Code:

00 12 71 03 00

Labor Operation:	Labor Allowance:	Description:
00 62 635	Refer to KSD2	Programming and coding in conjunction with another Campaign or repair (vehicle is already at the specified "Target" integration level or higher; no repair is necessary)
Or
00 62 634	Refer to KSD2	Program and code control units (includes connecting an approved battery charger/power supply and performing a vehicle test)

Labor operation codes 00 62 635 and 00 62 634 are both Plus labor operations.

Refer to KSD2 for the corresponding flat rate unit (FRU) allowance. Enter the Chassis Number, which consists of the last 7 digits of the Vehicle Identification Number (VIN). Click on the "Search" button, and then enter the applicable flat rate labor operation in the FR code field.

If control module(s) fail to reprogram or initializations are required, the additional work must be claimed using separate labor operations found in KSD2 under the defect code listed above.