12 51 240 Remove and install/replace Module 2, sensor system engine wiring: Notes
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER
- Remove the cover in the left engine compartment
- Remove the right cover in the engine compartment
- Refer to REMOVING AND INSTALLING TRAILING LINK ON SPRING STRUT DOME
- Remove the sound insulation on the bulkhead upper part center
- Refer to REMOVING ACOUSTIC COVER AT REAR
- Refer to REMOVING INTAKE SILENCER HOUSING
- Refer to REMOVING CLEAN AIR PIPE
- Refer to REMOVING CHARGE AIR LINE
- Refer to UNINSTALLING COVER FOR THE DME CONTROL UNIT
- Disconnect the connector from the DME control unit and from the power distribution module (PDM)
- Refer to REMOVING THE WIRING HARNESS SECTION FOR SENSOR SYSTEM 2
- Refer to INSTALLING THE WIRING HARNESS SECTION FOR SENSOR SYSTEM 2
Follow-up work
- Connect the connector to the DME control unit and the power distribution box (PDM)
- Refer to INSTALLING COVER FOR THE DME CONTROL UNIT
- Refer to INSTALLING CHARGE AIR LINE
- Refer to INSTALLING CLEAN AIR PIPE
- Refer to INSTALLING INTAKE SILENCER HOUSING
- Refer to INSTALLING ACOUSTIC COVER AT REAR
- Remove the sound insulation on the bulkhead upper part center
- Install tension strut on spring strut dome. Jointing torque: 56 Nm, angle of rotation: 90° NOTE: Replace screws.
- Install the cover in the engine compartment on the left
- Install the cover in the engine compartment on the right
- Refer to INSTALLING ACOUSTIC COVER