Electronic Brake Control Module: Service and Repair

1. Disconnect battery ground cable.
2. On wagon models, remove rear quarter trim panel as follows:
a. Pull top edge of lefthand side rear quarter trim panel from groove in quarter window garnish molding.
b. Pull tabs on quarter trim panel from slots in back body pillar and lock pillar trim panel.
c. Remove bottom edge of quarter trim panel from glove on load floor, then remove panel.
3. On all models, disconnect EBCM electrical connector.
4. Remove two EBCM to bracket attaching nuts, then the EBCM from the vehicle.
5. Reverse procedure to install, perform ABS system check as described under DIAGNOSIS AND TESTING PROCEDURE.