System Check
Use the System Check table as a guide to normal operation. Refer to diagnosis given if other results occur. Refer System Diagnosis for tests if a result is not normal.
SYSTEM CHECK
| Action | Normal Result |
|---|---|
| Ignition Switch in RUN | All lamp monitor display LEDs light for 3 seconds. If a bulb was inoperative at last operation, corresponding LED flashes for 10 seconds, then stays on. |
| Parking Lamps ON | If a parking lamp is out, corresponding lamp monitor display LED flashes 10 seconds than stays on. |
| Headlamps ON in LO position | If a LO beam headlamp is out, lamp monitor display LOW BEAM LED flashes 10 seconds then stays on. |
| Headlamps ON in HI position | If a LO beam headlamp is out, lamp monitor display HI BEAM LED flashes 10 seconds then stays on. |
| Press Brake pedal | If a brake lamp is out, lamp monitor display STOP LED flashes 10 seconds then stays on. |
| Operate Left turn signal | If a LH turn signal bulb is out, lamp monitor display LEFT TURN LED comes on. |
| Operate Right turn signal | If a RH turn signal bulb is out, lamp monitor display RIGHT TURN LED comes on. |
| Gear selector in REVERSE | If a back-up lamp is out, lamp monitor display BACK UP LED flashes 10 seconds then stays on. |