Body Control Module: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the battery ground (negative) cable.

IMPORTANT: Perform new BCM setup when you replace Body Control Module (BCM). Refer to BCM Programming/RPO Configuration. Programming and Relearning

2. Remove the left instrument panel insulator.
3. Disconnect the BCM electrical connectors.
4. Push the BCM up and move the bottom of the BCM away from and out of the mounting bracket slot in order to remove the BCM.

INSTALLATION PROCEDURE
1. Push the top of the BCM up into the mounting bracket in order to install the BCM. Then, while holding the BCM up, engage the bottom of the BCM into the mounting bracket slot.
2. Connect the BCM electrical connectors.
3. Install the left instrument panel insulator.
4. Connect the negative ground (negative) cable.