Keyless Entry Receiver: Service and Repair

REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT

REMOVAL PROCEDURE




1. Remove the front trim from inside of the rear storage compartment. Refer to Component Trim Panel Replacement - Rear in Trunk/Liftgate.




2. Disconnect the electrical connector.
3. Depress the retainer tabs (1).
4. Remove the remote control door lock receiver module (2).

INSTALLATION PROCEDURE




1. Snap the remote control door lock receiver module (2) into the slots in the rear compartment.
2. Connect the electrical connector.




3. Install the rear compartment trim. Refer to Compartment Trim Panel Replacement - Rear in Trunk/Liftgate.
4. Program the remote control door lock receiver module. Programming and Relearning