LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2002 >> LeSabre Custom, 4T65E/M15 >> Repair and Diagnosis >> Electrical >> Body Electrical >> Retained Accessory Power System >> Diagnostic Information & Procedures >> Scan Tool Data Definitions
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Scan Tool Data Definitions

  1. 8-Digit GM Part Number

    The scan tool displays an 8-digit alphanumeric number. This is the modules part number.

  2. Battery Voltage

    The scan tool displays 0-30 Volts. The voltage measured between the module's battery positive voltage circuit and ground circuit.

  3. Calibration ID

    The scan tool displays a 4-digit alphanumeric number. This number designates the modules calibrations.

  4. Driver Door Jamb Sw.

    The scan tool displays On/Off. Display indicates the state of the driver door jamb switch. On indicates the door is open and Off indicates the door is closed.

  5. Ign. Accessory

    The scan tool displays Active/Inactive. The scan tool displays Active when only the Accessory and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch.

  6. Ignition Crank/Run

    The scan tool displays Active/Inactive. The scan tool displays Active when the Crank/Run and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch.

  7. Ign. Run

    The scan tool displays Active/Inactive. The scan tool displays Active when the Run, Accessory, Run/Crank and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch.

  8. Ignition Switch

    The scan tool displays Accy./Crank/Off/RAP/RAP-Unlock/Run/Unlock. The scan tool displays Accy. when the accessory and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch. The scan tool displays Crank when the Crank/Run, and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch. The scan tool displays Off when none of the power moding circuits of the DIM receive a battery voltage signal from the ignition switch. The scan tool displays RAP when RAP is active and none of the power moding circuits of the DIM receive a battery voltage signal from the ignition switch. The scan tool displays RAP-Unlock when RAP is active and the Ign. Unlock circuit of the DIM receives a battery voltage signal from the ignition switch. The scan tool displays Run when all of the power moding circuits of the DIM receive a battery voltage signal from the ignition switch. The scan tool displays Unlock when the Unlock circuit of the DIM receives a battery voltage signal from the ignition switch.

  9. Ign. Unlock

    The scan tool displays Active/Inactive. The scan tool displays Active when only the Unlock circuit of the DIM receives a battery voltage signal from the ignition switch.

  10. Julian Date of Build

    The scan tool displays 3-digit numeric number. This is the day of the year that the module was built.

  11. Pass. Door Jamb Sw.

    The scan tool displays On/Off. Display indicates the state of the passenger door jamb switch. On indicates the door is open and Off indicates the door is closed.

  12. PROM ID

    The scan tool displays a 4-digit alphanumeric number. This is modules internal PROM identification number.

  13. RAP Output

    The scan tool displays On/Off. Display indicates the status of the RAP function.
scientia non olet · About LEMON Manuals