LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2002 >> Park Avenue Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Repair Instructions >> Electronic Brake Control Module (EBCM) Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Clean the seal surface of the BPMV.
  2. Install the EBCM (2) to the BPMV (1).
  3. Install the 6 EBCM to BPMV screws (2). Tighten the 6 screws to 3.2 N.m (28 in lbs).
  4. Connect the BPMV electrical connector (2) to the EBCM (3).
    NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
  5. Connect the EBCM electrical connector (1) to the EBCM (4).
  6. Rotate the EBCM connector tab (2) down to the locked position.
  7. Install the EBCM connector position assurance (2) to the EBCM electrical connector (1).
  8. Install the left front fascia extension.
  9. Install the left front wheel.
  10. Lower the vehicle.
  11. If a replacement EBCM is being installed, it must be programmed using the latest software matching the vehicle. Refer to the Techline Terminal/Equipment user's instructions.
  12. Use the scan tool in order to clear the DTCs.
  13. Fill and bleed the hydraulic brake system. Refer to MANUAL BLEEDING or PRESSURE BLEEDING .
  14. Perform the Auto Bleed Procedure. Refer to ABS Automated Bleed Procedure .
  15. Perform the ABS Diagnostic System Check. Refer to DIAGNOSTIC SYSTEM CHECK - ABS .
scientia non olet · About LEMON Manuals