Front Toe Adjustment
- Perform the following steps to remove the small seal clamp:
- Position the steering wheel in the straight ahead position.
- Loosen the hex nut on the tie rod (2). Turn the tie rod shaft (1) in order to obtain the proper toe angle. Refer to Figure.
- Confirm the number of threads showing on each tie rod end is nearly equal.
- Confirm that the tie rod ends (3) are square before you tighten the lock nuts (2).
Tighten:
Tighten the hex huts at the tie rod ends to 68 N.m (50 ft lbs)
NOTE: Ensure the seals do not twist. - Install the seal clamps.