LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2003 >> Century Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 435 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - LH >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Inflator Module Components
    GM307452Courtesy of GENERAL MOTORS CORP.
  1. Install the inflator module (1) to the driver seat back frame.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the inflator module fasteners (2).

    Tighten:  Tighten the fasteners (2) to 10 N.m (89 lb in).

  3. Gently pull the inflator module wiring harness (4) down into the seat cushion while guiding the harness through the wire triangle of the seat frame.
  4. Install the wiring harness retaining clips to the seat frame.
  5. Install the seat back cover. Refer to Seat Back Cover Replacement - Front in Seats.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 .
scientia non olet · About LEMON Manuals