Scan Tool Data List
Body Control Module (BCM) Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Battery Voltage | Data | Volts | 12.6 Volts |
| Crank | Inputs | Yes/No | No |
Instrument Panel Cluster (IPC) Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Crank | Data | Yes/No | No |
| Volt Lamp | Inputs | On/Off | Off |
Powertrain Control Module (PCM) Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Crank Request Signal | Engine Data 2 | Yes/No | No |
| GEN L-Terminal Signal Command | Engine Data 2 | On/Off | Off |
| Ignition 1 Signal | Engine Data 1, Engine Data 2 | Volts | 12.6 Volts |
| Starter Enable Relay Circuit Status | Outputs | OK/Fault/Invalid State | OK |
| Starter Relay Command | Engine Data 2 | On/Off | Off |
Transmission Control Module (TCM) Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF/Transmission in Park | |||
| IMS | Transmission Data | Park, Park/Reverse, Reverse, Reverse/Neutral, Neutral, Neutral/Drive 4, Drive 4, Drive 4/Drive 3, Drive 3, Drive 3/Drive 2, Drive 2, Drive 2/Drive 1, Drive 1, INVALID | Park |