Installation Procedure

Fig 1: Removing/Installing Rear Door Power Window Module

Courtesy of GENERAL MOTORS CORP.

Install the inside door handle and lock rods to the inside door handle.
Install the door latch onto the retainer on the power window module.
Install the inside door handle and lock rods to the door latch.
Install the door latch wiring harness to the power window module with the push-in connectors.
Connect the wiring connectors to the door latch.
Install the power window module (2) into the door.

Fig 2: Removing/Installing Rear Door Power Window Module Lower Fasteners

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the upper fasteners (1).
Tighten: Tighten the fasteners (1, 4) to 10 N.m (89 in. lb.).

Fig 3: Removing/Installing Rear Door Power Window Module

Courtesy of GENERAL MOTORS CORP.

Install the door latch fasteners (1).
Tighten: Tighten the fasteners to 10 N.m (89 in. lb.).
Install the outside door handle rod to the door latch.

Fig 4: Removing/Installing Rear Door Power Window Module Lower Fasteners

Courtesy of GENERAL MOTORS CORP.

Lower the window into the window module until the window clamp tabs (5) snap into place.
Connect the door latch wiring harness (3) to the door wiring harness.
Connect the power window motor wiring connector.
Check the window for proper adjustment. Refer to Window Adjustment - Rear Door .

Fig 5: Removing/Installing Door Trim Panel Bracket

Courtesy of GENERAL MOTORS CORP.

Install the trim panel bracket (1).
Install the fasteners (2).
Tighten: Tighten the fasteners to 9 N.m (80 in. lb.).
Install the water deflector. Refer to Water Deflector Replacement - Rear Door .
Install the door trim panel. Refer to Trim Panel Replacement - Side Rear Door .