Installation Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the CMP sensor.
Install the CMP sensor bolt.
Tighten: Tighten the bolt to 25 N.m (18 lb ft).
Connect the CMP sensor electrical connector.
Install the engine sight shield. Refer to Engine Sight Shield Replacement (6.0L (LQ4)) in Engine Mechanical 6.0L.