LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2005 >> Allure CXS >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Computer/Integrating Systems >> Repair Instructions >> Body Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the BCM to the BCM bracket.
    2. Fig 1: View Of BCM
    GM1202109Courtesy of GENERAL MOTORS CORP.
  2. Install the BCM and BCM bracket to the I/P.
    3. Fig 2: View Of BCM Screws
    GM1202105Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the BCM screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    4. Fig 3: View Of BCM Electrical Connectors
    GM1205342Courtesy of GENERAL MOTORS CORP.
  4. Connect the lower BCM electrical connectors. Engage the cam lock.
    5. Fig 4: View Of I/P Steering Column Opening Filler
    GM928912Courtesy of GENERAL MOTORS CORP.
  5. Install the knee bolster. Refer to Knee Bolster Replacement - Left in Instrument Panel, Gages, and Console.
    6. Fig 5: View Of I/P Insulator Fasteners
    GM1202960Courtesy of GENERAL MOTORS CORP.
  6. Install the left I/P insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel Gages and Console.
    7. Fig 6: Left Instrument Panel (I/P) Outer Trim Cover
    GM1283069Courtesy of GENERAL MOTORS CORP.
  7. Connect the upper electrical connector to the BCM. Engage the cam lock.
  8. Install the left I/P outer trim cover. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement in Instrument Panel, Gages, and Console.
  9. Perform the new BCM setup. Refer to Body Control Module (BCM) Programming/RPO Configuration .
scientia non olet · About LEMON Manuals