LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2005 >> Century Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Controls 3.1L (Introduction, Service & Replacement)) >> Repair Instructions >> Accelerator Controls Pedal Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Accelerator Cable & Components
    GM12287Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal (1) to the cowl (4).
    2. NOTE: Refer to Fastener Notice in Caution and Notices.
  2. Install the accelerator pedal bolt (3) and the stud (2).

    Tighten:  Tighten the bolt and the stud to 5 N.m (44 lb in).

  3. Install the accelerator cable (5) to the accelerator pedal (1).
    4. IMPORTANT: Inspect for complete throttle opening and closing positions by operating the accelerator pedal. Inspect for poor carpet fit under the accelerator pedal.
  4. Install the left instrument panel sound insulator. Refer toCloseout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals