Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of TP Sensor

Courtesy of GENERAL MOTORS CORP.

Install the TP sensor.
Apply thread-locking compound GM P/N 12345493 (Canadian P/N 10953488) or equivalent to the TP sensor screws.

Fig 2: Locating TP Sensor Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the two TP sensor screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 3: View Of TP Sensor & Connector

Courtesy of GENERAL MOTORS CORP.

Connect the TP sensor electrical connector.
Install the fuel injector sight shield. Refer toFuel Injector Sight Shield Replacement (L36)Fuel Injector Sight Shield Replacement (L67) in Engine Mechanical-3.8L.