Installation Procedure

NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: Removing/Installing Accelerator Controls Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Install the two brackets bolts.
Tighten: Tighten the bolts to 16 N.m (12 lb Ft).

Fig 2: Removing/Installing Electrical Wiring Harness At Accelerator Controls Bracket

Courtesy of GENERAL MOTORS CORP.

Install wiring harness clip (1) from bracket (3) if necessary.

Fig 3: Removing/Installing Accelerator Cable

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable (2) to the bracket (1).
Install the accelerator cable (2) to the throttle lever.

Fig 4: Removing/Installing Cruise Control Cable At Bracket

Courtesy of GENERAL MOTORS CORP.

Install the cruise control cable (1) to the bracket (2).
Install the cruise control cable (1) to the throttle lever.

IMPORTANT: The throttle should operate freely, without binding, between full closed and wide open throttle (WOT).

Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.
Install the fuel injection sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) or Fuel Injector Sight Shield Replacement (L67) in Engine Mechanical.