LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2005 >> Park Avenue Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Introduction >> Repair Instructions >> Accelerator Controls Cable Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Remove the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
    2. Fig 1: Removing/Installing Accelerator Control Cable At Accelerator Pedal Lever
    GM65171Courtesy of GENERAL MOTORS CORP.
  2. Remove the accelerator control cable (1) from the accelerator pedal (2) lever.
    3. Fig 2: Removing/Installing Accelerator Control Cable Through Bulkhead
    GM65179Courtesy of GENERAL MOTORS CORP.
  3. Squeeze the accelerator cable cover tangs and push the accelerator cable (1) through the bulkhead.
    4. Fig 3: Removing/Installing Accelerator Control Cable At Right Slot Top Of Washer Bottle
    GM65183Courtesy of GENERAL MOTORS CORP.
  4. Remove the accelerator control cable (1) from the retaining clip (2).
  5. Remove the accelerator control cable (1) from the right slot on top of washer bottle (3).
    6. Fig 4: Removing/Installing Accelerator Control Cable At Accelerator Control Bracket & Throttle Body Lever
    GM179148Courtesy of GENERAL MOTORS CORP.
  6. Remove the accelerator cable (2) from the throttle body lever (3).
    7. Fig 5: Removing/Installing Accelerator Control Cable At accelerator cable bracket
    GM179152Courtesy of GENERAL MOTORS CORP.
  7. Remove the accelerator cable (1) from the accelerator control cable bracket (2).
scientia non olet · About LEMON Manuals