LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2006 >> Lucerne CX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.8L - Introduction (2 Of 2) >> Repair Instructions >> Ignition Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Identifying Ignition Control Module Wiring Harness Electrical Connector
    GM1686624Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  3. Loosen the bolt securing the ignition control module (ICM) wiring harness electrical connector.
  4. Disconnect the ICM wiring harness electrical connector (2) from the ICM.
    5. Fig 2: Identifying Spark Plug Wires
    GM1693864Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the rear spark plug wires (1) from the ignition coils.
  6. Disconnect the front spark plug wires (2) from the ignition coils.
    7. Fig 3: Identifying Ignition Coil & Bolts
    GM1693822Courtesy of GENERAL MOTORS CORP.
  7. Remove the ignition coil bolts.
  8. Remove the ignition coils from the ICM.
    9. Fig 4: View Of ICM & Bracket
    GM1693880Courtesy of GENERAL MOTORS CORP.
  9. Remove the ICM from the bracket.
scientia non olet · About LEMON Manuals