LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2006 >> Lucerne CX >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Monitor System RECALIBRATION
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Tire Pressure Monitor System RECALIBRATION

CAUTION: DO NOT recalibrate TPM system until all problems are fixed and tire pressure in all 4 tires has been adjusted. If recalibration is done when tire pressures are incorrect, TPM system will not work properly and may not set an alert when a tire pressure is low or high.
  1. Ensure all tire pressures are adjusted to the pressure recommended on tire pressure label.
  2. Turn ON the ignition, with the engine OFF.
  3. Press and hold the vehicle information button until DIC display reads "PRESS TO RESET TIRE SYSTEM".
  4. Press and hold the SET button until "TIRE PRESSURE RESET" is displayed and a chime sounds 3 times.
  5. Release the SET button and TIRE PRESSURE NORMAL is displayed.
    NOTE: If low tire pressure warning message is still set, TPM system has not reset. Repeat procedure. If it does not work after two tries, refer to appropriate service information.
  6. After resetting, the TPM system requires about 20-45 minutes of driving in each of the following speed ranges to complete the calibration process:
    • 25-40 mph (40-64 km/h).
    • 40-60 mph (65-96 km/h).
    • 60-85 mph (96-136 km/h).
    NOTE: Learning process does not need to be completed during a single trip.
scientia non olet · About LEMON Manuals