Electronic Brake Control Module Replacement
Courtesy of GENERAL MOTORS CORP. Electronic Brake Control Module Replacement
| Callout |
Component Name |
|
NOTE:
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
Preliminary Procedures
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
- Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation
.
- Remove the left front inner wheelhouse liner. Refer to Front Wheelhouse Liner Replacement
.
|
| 1 |
Bolts, Electronic Brake Control Module (Qty: 4)
Tighten:
3 N.m (27 lb in)
|
| 2 |
Module, Electronic Brake Control
Tip:
- Clean the sealing surface of the brake pressure modulator valve with denatured alcohol and a clean shop cloth.
- Disconnect the electrical connector from the electronic brake control module.
- If a new electronic brake control module is installed, program the electronic brake control module. Refer to Service Programming System (SPS)
.
- If a new electronic brake control module is installed, program the electronic brake control module. Refer to Control Module References
.
|