Ignition Lock Cylinder Case Replacement

IGNITION LOCK CYLINDER CASE REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Refer to SIR Caution.

1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the ignition switch.
3. Remove the turn signal cancel cam.
4. Remove the park lock cable from the lock cylinder housing.






5. Remove 3 TORX screws.
6. Remove the lock cylinder housing from the steering column.

INSTALLATION PROCEDURE






NOTE: Refer to Fastener Notice.

1. Install 3 TORX screws into the lock cylinder housing.

Tighten
Tighten the TORX screws to 7 N.m (62 lb in).

2. Install the turn signal cancel cam.
3. Install the park lock cable into the lock cylinder housing.
4. Install the ignition switch.
5. Enable the SIR system. Refer to SIR Disabling and Enabling.