LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2007 >> Rendezvous CX >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    IMPORTANT: Use only new wave springs and screws supplied with the new EBCM.
    Fig 1: Separating/Installing EBCM From BPMV
    GM255233Courtesy of GENERAL MOTORS CORP.
  1. Clean the BPMV/EBCM mating surface using denatured alcohol and a clean towel.
  2. Install the EBCM (1) to the BPMV.
    3. NOTE: Refer to Fastener Notice .
  3. Install the 6 screws that attach the EBCM to the BPMV.

    Tighten: 

    • Tighten the top 4 mounting screws to 5 N.m (44 lb in). Tighten screws in an X pattern.
    • Tighten the bottom 2 mounting screws to 5 N.m (44 lb in).
    • Connect the pump motor connector to the bottom of the EBCM.

    4. Fig 2: Identifying EBCM Harness Connector
    GM230405Courtesy of GENERAL MOTORS CORP.
  4. Connect the EBCM harness connector and depress the locking tab (1) to secure.
  5. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  6. If installing a new EBCM, program the EBCM. Refer to Control Module References .
  7. Place the ignition switch in the RUN position. Do not start engine.
  8. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals