LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2007 >> Rendezvous CX >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Front Wheel Speed Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Front Wheel Speed Sensor Jumper Harness Electrical Connector
    GM385475Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The front wheel speed sensors and rings are integral with the hub and bearing assemblies.
    If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Do not service the harness pigtail individually because the harness pigtail is part of the sensor. Refer to Wheel Bearing/Hub Replacement - Front .
  1. Raise and support the vehicle on a suitable hoist. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the front wheel speed sensor jumper harness electrical connector (1) from the front wheel speed sensor connector (3).
    4. Fig 2: Hub & Bearing Assembly - Front
    GM188804Courtesy of GENERAL MOTORS CORP.
  4. Remove the hub and bearing assembly (2). Refer to Wheel Bearing/Hub Replacement - Front .
scientia non olet · About LEMON Manuals