Alarm Module: Service and Repair

Theft Deterrent Module Replacement

Removal Procedure

1. Disable the SIR. Refer to SIR Disabling and Enabling.
2. Remove the trim covers.
3. Remove the ignition lock cylinder.
4. Remove the theft deterrent module (TDM) wiring harness from the steering column harness.
5. Disconnect the electrical connector.




6. Pull the TDM (2) away from the lock cylinder housing (1).

Installation Procedure




1. Push the TDM (2) onto the lock cylinder housing (1).
2. Install the theft deterrent wiring harness to the steering column harness.
3. Connect the electrical connector.
4. Install the ignition lock cylinder.
5. Replace the steering column trim covers.
6. Enable the SIR system. Refer to SIR Disabling and Enabling.