Installation Procedure

Fig 1: Locating ECM Bracket & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the ECM bracket bolts.
Tighten: Tighten the ECM bracket bolts to 10 N.m (89 lb in).

Fig 2: View Of ECM Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: In order to prevent any possible electrostatic discharge damage to the ECM, do not touch the connector pins.

Fig 3: Identifying ECM Redundant Ground Wire And Bolt

Courtesy of GENERAL MOTORS CORP.

Install the ECM redundant ground and bolt to the ECM.
Tighten: Tighten the ECM redundant ground wire bolt to 5 N.m (44 lb in).

Fig 4: Locating Engine Side (Inboard) ECM Connector

Courtesy of GENERAL MOTORS CORP.

Fig 5: Identifying Engine Control Module Side Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the body side (outboard) ECM connector.
Install the ECM/TCM fuse in the underhood fuse block. Refer to Electrical Center Identification Views .
Install the TCM/IPC fuse in the underhood fuse block. Refer to Electrical Center Identification Views .
Install the ECM fuse in the underhood fuse block. Refer to Electrical Center Identification Views .
Connect the battery negative cable to the battery. Refer to Battery Negative Cable Disconnection and Connection (LY7) .
Program the ECM. Refer to Control Module References .
Turn OFF the ignition for at least 5 seconds after the programming event is complete.