Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the EVAP purge solenoid valve.
- Engine idling, command the EVAP vent closed with a scan tool.
- Increase the engine speed to 1,200-1,500 RPM.
- Observe the scan tool FTP sensor inches H2O. Verify the scan tool FTP sensor H2O parameter is -0.5 to +0.5 inches H2O.
- If greater than the specified range, replace the EVAP purge solenoid valve.
- Ignition OFF, disconnect the EVAP purge solenoid valve pipe.
- Ignition ON, observe the scan tool FTP sensor inches H2O parameter.
- Verify the FTP sensor is -0.5 to +0.5 inches H2O.
- If greater than the specified range, replace the FTP sensor.