Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Electrical Terminals

Courtesy of GENERAL MOTORS CORP.

Push in the electrical terminals (1). Ensure that the electrical terminals attach to the outside holes.
Gently tug on the wires to ensure that the terminals are seated and locked into position.

Fig 2: Identifying Locking Tabs

Courtesy of GENERAL MOTORS CORP.

Carefully insert the level sensor until the locking tabs (1) snap into the locked position.
Ensure that the level sensor wires are not pinched between the module and sensor.
Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .